Connecting To A Computer - Roland CAMM-3 PNC-3100 User Manual

Part 1

Connecting to a Computer

NOTICE
When connecting to a computer for the first time, be sure to perform an operation check to make sure the unit is
operating correctly.
Connect the PNC-3100 to the computer using the cable.
The cable for computer connection is optional. Please purchase the appropriate cable for the type of computer and
software used .
Parallel Connection
Connect the printer-use connector of the computer and
the parallel connector at the rear of the controller using
a parallel cable. Fix the cable securely in place using
the lock-use pins at both edges of the connector.
Serial Connection
Connect the RS-232C terminal of the computer and the
serial connector at the rear of the controller using a
serial cable. Fix the cable securely in place by tighten-
ing the screws attached to the cable using a screwdriver.
NOTICE
When making a serial connection, set the same
communication protocol (parameters) for both the
computer and for the PNC-3100. Refer to page 9
for setting the PNC-3100 communication param-
eters (protocol).
Lock-use pin
Lock-use pin
Screw
Screw
8
Parallel
connector
Serial
connector