DISPLAYED MESSAGES
DISPLAYED MESSAGE
FILL TANK!
GROUND TOO FINE ADJUST
MILL!
Insert water spout and press
ok
INSERT WATER SPOUT!
EMPTY GROUNDS CONTAINER
INSERT GROUNDS CONTAI-
NER
INSERT MILK CONTAINER!
ADD PRE-GROUND COFFEE!
POSSIBLE CAUSE
•
The water tank is empty or
positioned incorrectly.
•
The grinding is too fine and
the coffee runs off too
slowly.
•
The machine is not able to
make coffee.
•
The water spout is not
inserted or is inserted
incorrectly.
•
The grounds container (A9)
is full.
•
After cleaning, the grounds
container has not been
replaced.
•
The milk container is not
inserted.
•
The "pre-ground coffee"
function has been selected
without placing any pre-
ground coffee in the funnel.
40
REMEDY
•
Fill the tank with water
and/or insert it correctly,
pushing it as far as it will go
until it clicks into place.
•
Turn the grinding adjust-
ment
knob
one
towards the 7.
•
Insert the hot water spout,
press the
button and
run off water from the
spout for a few seconds
•
Insert the hot water spout.
•
Empty the grounds contai-
ner and clean, then replace.
Important: when removing
the drip tray, the grounds
container MUST be emp-
tied, even if it is not com-
pletely full. If this is not
done, when you make the
next coffees, the grounds
container may fill up more
than expected and clog the
machine.
•
Open the service door and
insert the grounds contai-
ner.
•
Insert milk container.
•
Add the pre-ground coffee
to the funnel or select the
"coffee beans" function.
click