Adjustment Of The Origin-Point Location; Adjusting The Location Of The Machine's Origin Point - Roland METAZA MPX-70 User Manual

5-4 Adjustment of the Origin-point Location

Adjusting the Location of the Machine's Origin Point

The machine's printing origin point is at the center of the table's scale. When you want to adjust the origin-point
location, output calibration data to verify the location of the origin point.
1.
Print calibration data.
Mount material on the center of the table.
Prepare material measuring at least 20 mm square.
p 30 "Mounting Material on the Table"
Start Dr. METAZA2.
Start printing.
2.
Measure and type in the correction values.
Center line
Material
Windows XP
Click [Start], then click [Control Panel].
Click [Printers and Other Hardware], then click [Printers and Faxes].
Windows 98 SE/Me/2000
Click [Start].
Click [Settings], then click [Printers].
The [Printers] folder opens.
70 Chapter 5 Maintenance and Adjustment
Measure and note down the offset between the centerline
on the table scale and the crossed lines on the material.
Positive direction
for [Length]
In the example shown in the figure, the [Width] value is displaced
by 0.5 mm in the positive direction and the [Length] value is offset
Positive direction
by 0.5 mm in the negative direction.
for [Width]
Center line
-0.5 mm
0.5 mm
Go to the [File] menu and click [Open].
For [Look in], select the [Samples] folder.
Select [Axis.dmz].
Click [Open].