When Copies Are Not Clear - Lanier 5618 Operator's Manual

When Copies are Not Clear

When Copies are Not Clear

Problem
Copies appear dirty.
The reverse side of an original
image is copied.
A shadow appears on copies if
you use pasted originals.
The same copy area is dirty
whenever making copies.
Copies are too light.
Parts of the image is not copied.
Copies are blank.
A watery or wavy pattern is
produced on copies.
6 - 10
Cause
The image density is set too
dark.
The image density is set too
dark.
The image density is too dark.
The exposure glass or
document feeder is dirty.
The image density is set too
high.
Damp or rough grained paper is
used.
Toner cartridge is almost
empty.
The original is not set correctly.
An improper paper size is
selected.
The original is not set properly.
Your original has a dot pattern
image or many lines.
Action
Adjust the image density.
Adjust the image density.
Adjust the image density.
Change the direction of the
originals.
Put tape on the pasted part.
Clean them.
Adjust the image density.
Use the recommended dry
paper.
Add toner.
Set the original correctly.
Select proper paper size.
When using the exposure glass,
set the originals face down.
When using the document
feeder, set the originals face
down.
Place the original on the
exposure glass at a slight angle.
Service and Supplies