Analog Modem Port - Fujitsu CT-10 User Manual

ANALOG MODEM PORT
The Analog Modem Port feature lets users with CT-20 and CT-30 model
telephones originate a data call from a PC equipped with a modem. The
analog modem port is located at the back of CT telephones equipped
with this feature.
You can only use the analog modem port when the telephone is idle.
This port does not accommodate simultaneous voice/data calls.
To activate the Analog Modem Port via a terminal:
NOTE
Activating the Analog Modem Port feature depends on the type of
terminal and software you are using.
1. Enter the modem off-hook command; e.g.,
ATDT
for the Hayes
Command mode.
2. Enter the code for an outside line and the destination
number, e.g., 95551212.
- The called extension answers.
3 Hang up by entering the on-hook command; e.g.,
ATHO
for the
Hayes Command mode.
NOTES
1. You must use an on-hook command from the terminal to reactivate
voice call.
2. You must use DTMF signals when dialing from an analog modem.
This means AT-DT should be used as the modem off-hook
command.
3. You can only originate a call via analog modem port. You cannot
terminate a call via the analoa modem port.
105