Table of Contents
Advertisement
Adjustment
1 Connect the ∅3.5 mm miniature plug (mono channel) to the adjustment monitor
output jack.
Important:
• This video output is intended for confirmation of view angle, etc. during installation or repair
service, and not for recording or monitoring.
Note:
• Adjustment monitor output jack is prior to video output cable. Video cannot be output through
the video output cable after connecting the adjustment monitor.
When the camera is installed on the wall, select "ON" for "UPSIDE-DOWN" in the setup
2
menu. (Refer to page 23 of Operating Instructions for detailed information)
Pan, tilt and azimuth adjustment
3
Important:
• When adjusting pan, tilt or azimuth, do not hold the lens of the camera.
Adjustment of panning position
1
Loosen the panning table lock screw and
rotate the table to determine the panning
position (adjustable range: -170 °
to +180 °).
• The panning position can be adjusted
between +180 ° (clockwise) and –170 °
(counter-clockwise).
• After the panning position is determined, fix
the panning table with the panning table
lock screw.
(Recommended torque: 0.39 N·m {0.29 lbf·ft})
Adjustment of tilting position
2
Turn the tilting table to adjust the tilting
position of the camera. (adjustable range:
0 to 75 °)
• Tighten the tilting lock screw after
adjustment.
(Recommended torque: 0.59 N·m {0.44 lbf·ft})
Panning table lock
screw [LOCK]
Clockwise: 180 °
Adjustable range: 0 to 75 °
Panning table
Original
position mark
Counter-clockwise: 170 °
19
Advertisement
Table of Contents
