Table of Contents
Advertisement
Preparations
When installing the camera on a wall or ceiling, there are two methods as specified below.
• Use the two-gang junction box
• Installing the camera directly on a wall or ceiling
Important:
• Procure 4 screws (M4) to secure the camera to a wall or ceiling according to the material of the
installation area. Do not use wood screws and nails. For mounting a camera on a concrete wall
or ceiling, use an anchor bolt (M4) for securing.
(Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
• Required pull-out strength of a single screw/bolt is 196 N or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the installation
area shall be sufficiently reinforced.
• The protection sheet attached to the dome section should be peeled off after installation.
The mounting conditions of the camera are described as follows:
Installation
place
Ceiling / wall
Ceiling / wall
Remove the dome cover
1 Peel off the protection sheet from the dome
cover. Don't remove completely as this
protects the dome during installation.
Loosen the dome cover fixing screw.
2
Adjust the mark on this unit to [|] on the
3
dome cover, and turn the dome cover
counterclockwise to remove it.
14
Applicable mount
bracket
Two-gang junction box
(locally procured)
(Direct mounting)
Recommended
Number
screw
of screw
M4
4 pcs.
M4
4 pcs.
Minimum pull-out
strength (per 1 pc.)
196 N
196 N
Dome cover
Cover
Fixing screw
Advertisement
Table of Contents
