Table of Contents
Advertisement
To keep on using with stable performance
Parts of this product may deteriorate and it
may shorten the lifetime of this product when
using in locations subject to high temperatures
and high humidity. (Recommended operating
temperature: +35 °C or lower)
Do not expose this product to direct heat
sources such as a heater.
Handle this product with care.
Do not drop this product, nor apply shock or
vibration to the product. Failure to observe this
may cause trouble. If a strong shock or vibration
is applied to the front cover, it may cause
damage or allow water to enter this product.
Do not touch the dome cover with your
bare hands.
A dirty dome cover causes deterioration of
picture quality.
Noise on monitor
This product is equipped with a super sensitive
CCD. Therefore, noise may appear on the
monitor. This phenomenon is not trouble.
Discoloration on the CCD color filter
When continuously shooting a bright light
source such as a spotlight, the color filter of
the CCD may have deteriorated and it may
cause discoloration. Even when changing the
fixed shooting direction after continuously
shooting a spotlight for a certain period, the
discoloration may remain.
Do not aim this product at strong light sources.
A light source such as a spot light causes a
blooming (light bleeding) or a smear (vertical lines).
Smear
Blooming
Bright subject
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury. Do not
use strong abrasive detergent when cleaning
this product. Otherwise, it may cause
discoloration. When using a chemical cloth for
cleaning, read the caution provided with the
chemical cloth product.
Cleaning the lens
Use a lens cleaning paper (used to clean
camera lenses or lenses of spectacles). When
using solvent, use an alcohols solvent and do
not use a thinner or a glass cleaner.
Synchronous mode setting
Image synchronous mode of this camera
indicates internal synchronization (INT) only. Set
the multiplexed vertical drive (VD2) as OFF
when the camera is connected to the system
controller of the company.
9
Advertisement
Table of Contents
