Configure Vlan - HP 4800G Series Configuration Manual

[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.128
# Create a VRRP group 1 and set its virtual IP address to 202.38.160.100.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.100
[SwitchB-Vlan-interface2] quit

# Configure VLAN 3.

[SwitchB] vlan 3
[SwitchB-vlan3] port gigabitethernet 1/0/6
[SwitchB-vlan3] quit
[SwitchB] interface vlan-interface 3
[SwitchB-Vlan-interface3] ip address 202.38.160.131 255.255.255.128
# Create a VRRP group 2 and set its virtual IP address to 202.38.160.200.
[SwitchB-Vlan-interface3] vrrp vrid 2 virtual-ip 202.38.160.200
# Configure the priority of Switch B in VRRP group 2 to 110.
[SwitchB-Vlan-interface3] vrrp vrid 2 priority 110
3) Verify the configuration
You can use the display vrrp verbose command to verify the configuration.
# Display detailed information of the VRRP group on Switch A.
[SwitchA-Vlan-interface3] display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Total number of virtual routers: 2
Interface : Vlan-interface2
VRID : 1
Admin Status : UP
Config Pri : 110
Preempt Mode : YES
Auth Type : NONE
Virtual IP : 202.38.160.100
Virtual MAC : 0000-5e00-0101
Master IP : 202.38.160.1
Interface : Vlan-interface3
VRID : 2
Admin Status : UP
Config Pri : 100
Preempt Mode : YES
Auth Type : NONE
Virtual IP : 202.38.160.200
Master IP : 202.38.160.131
# Display detailed information of the VRRP group on Switch B.
[SwitchB-Vlan-interface3] display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Total number of virtual routers: 2
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0
Adver. Timer : 1
State : Backup
Run Pri : 100
Delay Time : 0
1-24