HP 4800G Series Configuration Manual page 1247

Table of Contents

All clients belong to default domain aabbcc.net, which can accommodate up to 30 users. RADIUS

authentication is performed at first, and then local authentication when no response from the

RADIUS server is received. If the RADIUS accounting fails, the device gets users offline.

A server group with two RADIUS servers is connected to the device. The IP addresses of the

authentication/secondary

authentication/primary accounting server.

Set the shared key for the device to exchange packets with the authentication server as name, and

that for the device to exchange packets with the accounting server as money.

Specify the device to try up to five times at an interval of 5 seconds in transmitting a packet to the

RADIUS server until it receives a response from the server, and to send real time accounting

packets to the accounting server every 15 minutes.

Specify the device to remove the domain name from the username before passing the username to

the RADIUS server.

Set the username of the 802.1X user as localuser and the password as localpass and specify to

use clear text mode. Enable the idle cut function to get the user offline whenever the user remains

idle for over 20 minutes.

Figure 1-10 Network diagram for 802.1X configuration

Configuration procedure

The following configuration procedure covers most AAA/RADIUS configuration commands for the

device, while configuration on the 802.1X client and RADIUS server are omitted. For information about

AAA/RADIUS configuration commands, refer to AAA Configuration in the Security Volume.

# Configure the IP addresses for each interface. (Omitted)

# Add local access user localuser, enable the idle cut function, and set the idle cut interval.

<Device> system-view

[Device] local-user localuser

[Device-luser-localuser] service-type lan-access

[Device-luser-localuser] password simple localpass

respectively.

Chapters

Table of Contents