HP 4800G Series Configuration Manual page 1287

Select Portal Service Management > Device from the navigation tree to enter the portal device
configuration page. Then, click Add to enter the page for adding a portal device, as shown in
Type the device name Switch.
Type the IP address of the interface on the switch for connecting the user.
Type the key, which must be the same as that configured on the switch.
Set whether to enable IP address reallocation. Direction portal authentication is used in this
example, and therefore select No from the Reallocate IP drop-down list.
Figure 1-7 Add a portal device
# Associate the portal device with the IP address group.
As shown in Figure 1-8, in the device list on the portal device configuration page, click the icon in the
Port Group Information Management column of device Switch to enter the port group configuration
page.
Figure 1-8 Device list
On the port group configuration page, click Add to enter the page for adding a port group, as shown in
Figure 1-9. Perform the following configurations:
Type the port group name.
Select the configured IP address group. Note that the IP address used by the user to access the
network must be within this IP address group.
1-13
Figure 1-7.