MULTIQUIP Power WHISPERWATT DCA150SSI Operation And Parts Manual page 38

Whisperwatt series 60hz generator (isuzu 6hkix diesel engine)
Hide thumbs Also See for Power WHISPERWATT DCA150SSI:
Table of Contents

Advertisement

If the engine is operating in very dusty or dry grass
conditions, a clogged air cleaner will result. This can lead to
a loss of power, excessive carbon buildup in the combustion
chamber and high fuel consumption. change air cleaner
more frequently if these conditions exists.
Fuel aDDItIon
Add diesel fuel (the grade may vary according to season
and locations).
Removing Water from the Fuel Tank
After prolonged use, water and other impurities accumulate
in the bottom of the tank. Occasionally inspect the fuel
tank for water contamination and drain the contents if
required.
During cold weather, the more empty volume inside the
tank, the easier it is for water to condense. This can be
reduced by keeping the tank full with diesel fuel.
cleaning Inside the Fuel Tank
If necessary, drain the fuel inside the fuel tank completely.
Using a spray washer (Figure 57) wash out any deposits
or debris that have accumulated inside the fuel tank.
figure 57.
fuel Tank Cleaning
page 38 — DCa150SSI/DCa150SSIu 60 hz gen. • operatIon anD partS manual — rev. #0 (11/23/09)
Fuel tanK InSpeCtIon
In addition to cleaning the fuel tank, the following
components should be inspected for wear:
rubber Suspension
deformity due to contact with oil. Replace the rubber
suspension if necessary.
Fuel hoses
— inspect nylon and rubber hoses for signs
of wear, deterioration and hardening.
Fueltank lining
— inspect the fuel tank lining for signs
of excessive amounts of oil or other foreign matter.
Replacing Fuel Filter
Replace the fuel filter cartridge with new one every 500
hours or so.
Loosen the drain plug at the lower top of the fuel filter.
Drain the fuel in the fuel body together with the mixed
water. Do not spill the fuel during disassembly.
Vent any air
aIr removal
If air enters the fuel injection system of a diesel engine,
starting becomes impossible. After running out of fuel,
or after disassembling the fuel system, bleed the system
according to the following procedure. See the iSUZU
engine manual for details.
To restart after running out of fuel, turn the switch to the
"ON" position for 15-30 seconds. Try again, if needed.
MAINTENANCE
— look for signs of wear or

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power whisperwatt dca150ssiu

Table of Contents