Output Terminal Panel Connections - MULTIQUIP Power WHISPERWATT DCA150SSI Operation And Parts Manual

uvWo termInal output voltageS
Various output voltages can be obtained using the UVWO
output terminal lugs. The voltages at the terminals are
dependent on the position of the voltage Selector Switch
and the adjustment of the voltage regulator Control
Knob.
Remember the voltage selector switch determines the
range of the output voltage. The voltage regulator (VR)
allows the user to increase or decrease the selected
voltage.
3Ø-240/139 UVWO Terminal Output Voltages
1. Place the voltage selector switch in the 3Ø 240/139
position as shown in Figure 19..
figure 19. Voltage Selector Switch
3Ø-240/139V Position
2. connect the load wires to the UVWO terminals as
shown in Figure 20.
figure 20. UVWO Terminal Lugs
3Ø-240/139V Connections
page 28 — DCa150SSI/DCa150SSIu 60 hz gen. • operatIon anD partS manual — rev. #0 (11/23/09)

OUTPUT TErMINAL PANEL CONNECTIONS

3. Turn the voltage regulator knob (Figure 21) clockwise
to increase voltage output, turn counterclockwise to
decrease voltage output. Use voltage regulator
adjustment knob whenever fine tuning of the output
voltage is required.
3Ø-208V/1Ø-120V UVWO Terminal Output Voltages
1. Place the voltage selector switch in the 3Ø 240/139
position as shown in Figure 22.
2. connect the load wires to the UVWO terminals as
shown in Figure 23.
3Ø-208/1Ø-120V Connections Connections
NOTICE
To achieve a 3Ø 208V output the voltage selector switch
must be in the 3Ø-240/139 position and the voltage
regulator must be adjusted to 208V..
figure 21. Voltage regulator knob
figure 22. Voltage Selector Switch
3Ø-240/139V Position
figure 23. UVWO Terminal Lugs