Installing A Flash Memory Or Firmware Card - Lexmark T656dne User Manual

Hide thumbs Also See for T656dne:
Table of Contents

Advertisement

Additional printer setup
1
Notches
2
Ridges
5
Push the memory card straight into the connector until it snaps into place.
6
Replace the system board cover and close the system board door.

Installing a flash memory or firmware card

Note: This task requires a flathead screwdriver.
The system board has two connections for an optional flash memory or firmware card. Only one of each may be installed,
but the connectors are interchangeable.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
1
2
3
21

Advertisement

Table of Contents
loading

Table of Contents