Kodak 805 User Manual page 62

2. Use a lint-free cloth moistened with isopropyl alcohol or distilled water to
clean the print head, and wipe along the heater line four times:
• Wipe the full length of the area (always in one direction).
• Use a clean part of the cloth for each wipe.
• Apply firm, even pressure.
• Wipe only the following areas.
Guide bar
Heater line
3. Allow the wiped area to dry for about two minutes.
4. Close the top cover and turn on the printer.
5. Make a test print.
NOTE: It may be necessary to repeat Steps 1- 5 several times to remove any
artifacts. If you cannot remove the artifacts, call for service.
CONTENTS
SEARCH
HELP
Introduction
Setting up the Printer
Operating the Printer
Troubleshooting
Site Specifications
Accessories and
Supplies