Table of Contents
Advertisement
10.2.4. Checking interfaces
Refer to the instruction manual for each interface, available on our website.
10.2.5. Checking the testing terminal
The Chc r5 display is for checking the testing terminal. Do not use it.
10.2.6. Checking the A/D (load cell)
With Chc ad displayed, press the ENTER key to enter the A/D check mode. The load cell
output value is displayed in mV/V.
The example below is when the internal count is 1.23456 mV/V.
1 . 2 3 4 5 6
10.2.7. Checking the internal count
With Chc in displayed, press the ENTER key to enter the internal count check mode.
The internal count value (display value times 10) is displayed.
The example below is when the internal count is 123.
1 2 3 .
10.2.8. Checking the program version
Chcpr9
With
displayed, press the ENTER key to display the version of the current
program. The example below is when the program version is 1.00.
p
0 0
1 . 0 0
10.2.9. Checking the serial number
With Chc 5n displayed, press the ENTER key to display the last five digits of the serial
number. The example below is when the last five digits of the serial number are 12345.
1 2 3 4 5 .
10.2.10. Checking the program checksum
With C5 pr9 displayed, press the ENTER key to display the program checksum. The
example below is when the checksum is EF.
C 5
0 0
e f
Page 39
AD-4408A
Advertisement
Table of Contents
