Mode Map - A&D AD-4408A Instruction Manual

6.2. Mode Map

The indicator has several modes to perform various operations.
Perform mode switching by key operation as shown below, only in the direction of the
solid arrow.
After setting a mode, the indicator resets automatically. Alternately, the indicator resets,
when the power is disconnected.
Power ON
See the note
below.
NOTE: When the power is
disconnected while in
the OFF mode, the
indicator will start in
the OFF mode when
power is re-connected.
AD-4408A
Weighing
mode
Switch using
the ON/OFF key
OFF
mode
Automatic reset after setting
General
function mode
Enter using the key combination
ENTER + F
Maintenance
mode
Enter using the key combinations
ENTER + F
and then
ZERO + ENTER
Calibration
mode
Enter using the CAL key
Fig.6 Mode map
Page 18
Check
mode
Initialization
mode
Calibration using
an actual load
Calibration-related
function mode
All data
initialization mode