Preparing To Use Your Phone; The Pack Contains; Installing The Phone - Siemens W10 User Manual

Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03
Preparing to use the phone

The pack contains:

Base
Handset
Microphone.
Microphone cord (coiled)
Rechargeable batteries
Charger
Phone cord
Two power supply units with power cord
One set of operating instruction

Installing the phone

1. To open the battery compartment, press the battery cover of the handset and slide it down.
2. Insert the battery plug into the socket in the battery compartment and place the batteries
into the battery compartment
3. Push up the battery cover
4. Place the handset with batteries into the charger
5. Insert small jack of the power supply unit into the socket on the back of the charger, and
then plug the other end into the 220V power outlet.
6. Raise the antenna
7. Insert the jack on the power supply unit into the socket on the back of the base, and then
plug the power supply unit into your power outlet. When the LED on the base lights up,
the base is powered.
Note: For the initial charge we recommend a continuous, uninterrupted charging period of
more than twelve hours before use.
8. Fit the small jack on the phone cord into the socket in the base and fit the other end into
phone outlet.
9. If "Ringer Off" is shown on the display, please set the ringer tone to "ON" according tothe
descriptions in the "Ring switch" section.
4