Storing The Incoming Call Numbers To The Directory (Base And Handset); Deleting Individual Incoming Call Numbers; Deleting All Incoming Numbers; Browsing And Dial The Incoming Numbers - Siemens W10 User Manual

Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03
Press again the same key to delete the selected record.
Storing the incoming call numbers to the directory
(base and handset)
Be sure the base and the handset is in standby.
Press CID key.
Press or key to browse and select incoming call records.
Press the Mem/Prog key.
Then enter two digits (01-16) of the location where the number
should be stored.
Note: the "0" in the "01" cannot be omitted.
Deleting a single incoming call number
Be sure the handset or the base is in standby.
Press CID key.
Press or key to browse and select the incoming records.
Then press the Delete key on the handset or the base, and then
the screen will display "Delete".
Press "Delete" again to delete the selected record.

Deleting all incoming numbers

Be sure the handset or the base is in standby.
Press the CID key.
Then long press the Flash/Clear key on the handset or the base.
Do not release it until the screen displays "Delete All".
Press "Delete" again to delete all the records.

Browsing and dial the incoming numbers

Be sure the handset or the base is in standby.
Press CID key.
Press or key to browse and select the incoming records.
If too long, press the 0/Turn Page (Next) key to display other
records.
Then press the Talk key on the handset or the Hand-free/Dial
Back key on the base to dial the selected number.

Directory

The handset and the base can respectively store 16 20-digit
17