Log Commands; Configuring What You Want The Prestige To Log; Figure 206 Displaying Log Categories Example; Figure 207 Displaying Log Parameters Example - ZyXEL Communications P-861H-G2 User Manual

Table 127 RFC-2408 ISAKMP Payload Types (continued)
LOG DISPLAY
SIG
NONCE
NOTFY
DEL
VID

Log Commands

Go to the command interpreter interface.

Configuring What You Want the Prestige to Log

1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the Prestige is to record.
2 Use sys logs category to view a list of the log categories.

Figure 206 Displaying Log Categories Example

3 Use sys logs category followed by a log category to display the parameters that are
available for the category.

Figure 207 Displaying Log Parameters Example

4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Appendix H Log Descriptions
PAYLOAD TYPE
Signature
Nonce
Notification
Delete
Vendor ID
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras>?
Valid commands are:
sys exit
ip ipsec
certificates cnm
ras>
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/
1:show debug type]
Prestige 861H Series User's Guide
ether aux
bridge bm
8021x radius
328