Prestige 861H Series User's Guide
Only use firmware for your device's specific model. Refer to the label on the bottom of your
device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your Prestige.
Figure 61 Firmware Upgrade
The following table describes the labels in this screen.
Table 33 Firmware Upgrade
LABEL
File Path
Browse...
Upload
Reset
Note: Do not turn off the Prestige while firmware upload is in progress!
After you see the Firmware Upload in Process screen, wait two minutes before logging into
the Prestige again.
The Prestige automatically restarts in this time causing a temporary network disconnect. In
some operating systems, you may see the following icon on your desktop.
Figure 62 Network Temporarily Disconnected
After two minutes, log in again and check your new firmware version in the System Status
screen.
If the upload was not successful, the following screen will appear. Click Back to go back to
the Firmware screen.
129
DESCRIPTION
Type in the location of the file you want to upload in this field or click Browse ... to find it.
Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Click Upload to begin the upload process. This process may take up to two minutes.
Click this button to clear all user-entered configuration information and return the
Prestige to its factory defaults.
Chapter 12 Maintenance