Power Button Function - Intel MS-6112 User Manual

Display Activity/Device 6/Device 7/Device 8/Device 5/Device
0/Device 1/Device 1/Device 2/Device 3/System Thermal
When set to Monitor, these options enable event monitoring on the
specified hardware interrupt request line. If set to Monitor and the computer
is in a power saving state, AMI® BIOS watches for activity on the specified
IRQ line. The computer enters the full on power state if any activity occurs.
AMI® BIOS reloads the Standby and Suspend timeout timers if
activity occurs on the specified IRQ line.

Power Button Function

During Suspend, if you push the switch one time, the system goes
into suspend mode and if you push it more than 4 seconds, the system will
be turned off. During On/Off, the system will turn off once you push the
switch.
Ring Resume from Soft-Off
During Disabled, the system will ignore any incoming call from the
modem. During Enabled, the system will boot up if there's an incoming call
from the modem.
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system. Then, power off the system. This
function will work the next time you power on.
RTC Alarm Resume From Soft-Off
This function is for setting the Date, Hour, Minute, and Second for
your computer to boot up. During Disabled, you cannot use this function.
During Enabled, Choose the Date, Hour, Minute, and Second:
RTC Alarm Date
RTC Alarm Hour
RTC Alarm Minute
RTC Alarm Second
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system. Then, power off the system. This
function will work the next time you power on.
Choose which day the system will boot up.
Choose which hour the system will boot up.
Choose which minute the system will boot up.
Choose which second the system will boot up.
3-19
®