Before You Begin; What Is Included; Unpacking Instructions; Ac Power - Chauvet LED Mushroom User Manual

1. B
EFORE

What is Included

Ø
1 x LED Mushroom
Ø
Power Cord

Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned to the factory, it is important that the fixture be returned in the original factory box
and packing.

AC Power

This fixture has an auto-switching power supply that can accommodate a wide range of input
voltages. The only thing necessary to do before powering on the unit is to make sure the line voltage
you are applying is within the range of accepted voltages. This fixture will accommodate between
100V and 240V AC 50-60 Hz. All fixtures must be powered directly off a switched circuit and cannot
be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is
used solely for a 0–100% switch.

Safety Instructions

·
Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that
they also receive this instruction booklet.
·
Always make sure that you are connecting to the proper voltage, and that the line voltage you are
connecting to is not higher than that stated on the decal or rear panel of the fixture.
·
This product is intended for indoor use only! (If applicable)
·
To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no
flammable materials close to the unit while operating.
·
The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent
surfaces. Be sure that no ventilation slots are blocked.
·
Always disconnect from power source before servicing or replacing lamp or fuse and be sure to
replace with same lamp source.
·
Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use
its carrying handles.
·
Maximum ambient temperature (Ta) is 104°F (40°C). Do not operate fixture at temperatures higher
than this.
·
In the event of a serious operating problem, stop using the unit immediately. Never try to repair the
unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. Always use the same type spare parts.
·
Never connect the device to a dimmer pack.
·
Make sure the power cord is never crimped or damaged.
·
Never disconnect the power cord by pulling or tugging on the cord.
·
Avoid direct eye exposure to the light source while it is on.
·
Do not daisy chain power to more than 37 units @ 120V and 70 @ 230V.
Caution! There are no user-serviceable parts. Do not open the housing or attempt any
repairs yourself. In the unlikely event your unit may require service, please contact
CHAUVET® at: 954-577-4455.
LED Mushroom User Manual
Y B
OU EGIN
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance of this
product.
3
Ø
Warranty Card
Ø
User Manual
Rev. 4