Setup; Ac Power; Mounting; Orientation - Chauvet Scorpion User Manual

3. S
ETUP

AC Power

This product has an auto-switching power supply that can accommodate a wide range of input
voltages. The only thing necessary to do before powering on the unit is to make sure the line
voltage you are applying is within the range of accepted voltages. This product will
accommodate between 100V and 240V AC 50-60 Hz.
Power Supply
To determine the power requirements for a particular product, see the label affixed to the back
plate of the product or refer to the product's specifications chart. A product's listed current rating
indicates its average current draw under normal conditions.
Always connect the product to a switched circuit. Never connect the product to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0
to 100% switch.

Mounting

Orientation

This product may be mounted in any safe position, provided there is adequate room for
ventilation.

Rigging

It is important never to obstruct the fan or vents pathway. Mount the
product using, a suitable "C" or "O" type clamp. Adjust the angle of
the product by loosening both knobs and tilting the product. After finding
the desired position, retighten both knobs.
·
·
·
Scorpion™ Storm MG User Manual Rev. 7
When selecting installation location, take into consideration
access and routine maintenance.
Safety cables must always be used.
Never mount in places where the product will be exposed
to rain, high humidity, extreme temperature changes or
restricted ventilation.
10
Hanging Clamp
Note!
Clamp is sold separately.
06/14/2013