Table of Contents
Advertisement
Wireless
Remote
Operation
Page 10 of 14
The Hurricane™ 901 can operate with the optional wireless remote control (model
FC-W). This control allows the user to start and stop the fog output manually without the
limitations of the wired remote controls.
The FC-W consists of a receiver and a key chain transmitter. The transmitter has four
control buttons, each of them assigned to a specific channel. The receiver has four DIP
switches to tune it on one of those four channels. This allows the operator to control up
to four independent Hurricane™ 901 units. It is also possible to control more than four
Hurricane™ 901 units by assigning the same receiving channel to more than one
Hurricane™ 901 unit.
To operate this product, follow the instructions below:
1) Plug the fog machine into power and turn the power switch to the fixture on.
2) Plug in the wireless remote control receiver FC-W into the Remote Control socket on
the rear of the fog machine.
3) Select the receiving channel by configuring the DIP switch as follows:
Channel
1
2
3
4
4) Press the corresponding button on the FC-W transmitter and the Hurricane™ 901
will output fog for as long as you keep that button pressed.
Antenna
Fog
Triggers
Red LED
(Send)
Transmitter
The Hurricane™ 901 unit may stop producing fog to allow for fluid reheating after
a period of continuous fog output. This is a normal occurrence.
DIP Switches
1
2
ON
Off
Off
ON
Off
Off
Off
Off
Green
LED
(Ready)
DIP
Switches
Sliding
Key Cover
Key chain
Loop
3
4
Off
Off
Off
Off
ON
Off
Off
ON
Red LED
(Heating)
Receiver
Hurricane™ 901 User Manual Rev. 3
Advertisement
Table of Contents
