Table of Contents
Advertisement
Infrared Control
IRC-6 (Infrared Remote Control 6) Operation
Page 10 of 17
The COLORrail™ IRC IP is fully compatible with the IRC-6 infrared remote control from
CHAUVET® (sold separately). To enable the infrared functionality with the COLORrail™
IRC IP, follow the instructions below:
·
Press <MENU> repeatedly until ir- shows on the display.
Note: Make sure to point the IRC-6 directly at the receiver on the
product.
Automatic Mode
Automatic mode will enable you to run the automatic programs on the
product.
To turn on Automatic mode:
1.
Press <AUTO> on the IRC-6.
2.
Press <+> or <–> to choose between the different auto programs.
To adjust the speed of the automatic program:
1.
Press <SPEED> on the IRC-6.
2.
Press <%>.
3.
Press <+> or <–> to either increase or decrease the speed of the
program.
Manual Color Control
To choose a specific color with the IRC-6:
1.
Press <MANUAL> on the IRC-6.
2.
Press any number between <0> and <9> to choose your color.
To manually control the RGB percentage:
1.
Press <MANUAL> on the IRC-6.
2.
Press <R>, <G>, <B>, (red, green, blue) to choose your color.
3.
Press <+> or <–> to increase or decrease the percentage of each color.
Strobe
To adjust the strobe rate of any program that has a strobe function:
1.
Press <STROBE> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the strobe rate.
3.
Press <STROBE> again to turn off the strobe.
Note: Strobe will only work on the Auto programs that include a
strobe option.
Blackout
Pressing <BLACK OUT> on the IRC-6 turns off all the lights until the button
is pressed again.
Note: The IRC-6 will not respond to any inputs when Black Out
is activated. If the remote does not respond when a button is
pressed,
try
inadvertently activated Black Out.
pressing
<BLACK
OUT>.
COLORrail™ IRC IP User Manual Rev. 5
You
may
have
Advertisement
Table of Contents
