Integra DTR-40.4 Instruction Manual page 31

Tuning into Radio Stations
■
Auto tuning mode
1 Press Tuning Mode so that the AUTO indicator
lights on the AV receiver's display.
2
Press Tuning / .
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
1
Press Tuning Mode so that the AUTO indicator
goes off on the AV receiver's display.
2
Press and hold Tuning / .
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by entering
the appropriate frequency.
1 On the remote controller, press Tuner repeatedly
to select "AM" or "FM", followed by D.TUN.
(Actual display depends on the country.)
2
Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
TUNED
For example, to tune to 87.5 (FM), press 8, 7, 5 or 8,
AUTO
7, 5, 0.
If you have entered the wrong number, you can retry
after 8 seconds.
FM STEREO
Presetting AM/FM Stations
You can store a combination of up to 40 of your favorite
AM/FM radio stations as presets.
1 Tune into the AM/FM station that you want to store
as a preset.
See the previous section.
2
Press Memory.
The preset number flashes.
(Actual display depends on the country.)
3 While the preset number is flashing (about 8
seconds), use Preset
through 40.
/ to select a preset from 1
En-31
Turning On & Basic Operations
4
Press Memory again to store the station or channel.
The station or channel is stored and the preset number
stops flashing.
Repeat this procedure for all of your favorite AM/FM
radio stations.
■
Selecting Presets
1
To select a preset, use Preset
receiver, or the remote controller's CH +/–.
Tip
• You can also use the remote controller's number buttons to
select a preset directly.
■
Deleting Presets
1 Select the preset that you want to delete.
See the previous section.
2
While holding down Memory, press Tuning Mode.
The preset is deleted and its number disappears from
the AV receiver's display.
/ on the AV