Table of Contents
Advertisement
Menu
Press the menu button to open the on-screen menus. Press menu again to
close the menus. When you close the menus, the projector saves any changes
that you made. For more information about the on-screen menus, see "Using
the on-screen menus" on page 16.
Source (keypad only) or computer and video (remote control only)
When you have more than one source (computer and video) connected to the
projector, select between them by pressing the source button on the keypad or
the computer or video button on the remote control.
Standby
When you press the standby button, the display and audio turn off and a
blank screen is displayed for 15 minutes. You can change the amount of time
the projector stays in standby mode; see "Standby time" on page 23 for
details.
v If you press the standby button again within 15 minutes, the projector
returns to operation immediately.
v If you press standby again after 15 minutes, there is approximately a
60-second delay before the lamp turns back on.
v If you do not press standby again, the lamp turns off after 15 minutes.
Volume (keypad only)
To increase the volume, press the volume + button. To decrease the volume,
press the volume - button.
Volume adjustments are saved for each source that you have connected.
Installation and user's guide
15
Advertisement
Table of Contents
