IBM iL2215 User Manual page 19

Note: Your video player might also have a "Video Out" connector for a
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
— Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration
of this product during an electrical storm.
— Connect all power cords to a properly wired and grounded electrical outlet.
— Connect to properly wired outlets any equipment that will be attached to this product.
— When possible, use one hand only to connect or disconnect signal cables.
— Never turn on any equipment when there is evidence of fire, water, or structural damage.
— Disconnect the attached power cords, telecommunications systems, networks, and modems and
modems before you open the device covers, unless instructed otherwise in the installation and
configuration procedures.
— Connect and disconnect cables as described in the following table when installing, moving, or
opening covers on this product or attached devices.
To connect:
1. Turn everything OFF.
2. First attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
Starting the projector and adjusting the image
Use the following procedure to start the projector and adjust the image.
Note: Always use the power cord that comes with the projector.
1. Remove the lens cap.
2. Plug the power cord into the side of the projector, and then plug it into an
electrical outlet. A surge-protected power strip is recommended. The fans
start to run, and the Lamp LED on the top of the projector lights orange
until the software has initialized. When initialization is complete, the
Lamp LED lights green. A green Lamp LED indicates that you can press
the lamp on/offbutton to turn the lamp on and off.
Note: The first time you connect your computer to the projector, the
coaxial cable connection. Do not use this to connect to the projector.
computer might display a message stating that new hardware was
To disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
Installation and user's guide
9