Removing A Memory Module - Lenovo ThinkServer RD240 Installation And User Manual

6. Position the new memory module over the memory slot. Make sure that the
notch 1 on the new memory module is aligned with the key 2 in the
memory slot. Then, press the new memory module straight down into the
memory slot until the retaining clips close and the new memory module snaps
into position.
Note: If there is a gap between the memory module and the retaining clips, the
memory module has not been correctly installed. Open the retaining
clips, remove the memory module, and then reinstall it into the slot.
Figure 10. Installing the memory module
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation, go to "Completing the parts replacement" on
page 67.

Removing a memory module

Attention
Do not open your server or attempt any repair before reading and understanding the Safety
Information and the Warranty and Support Information on the ThinkServer Documentation DVD
that comes with your product, and "Guidelines" on page 19. To obtain a copy of the
publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove a memory module.
To remove a memory module, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 21.
3. Locate the memory slot with the memory module that you want to remove. See
"Locating parts on the system board" on page 15 for the locations of the
memory slots.
Chapter 5. Installing, removing, or replacing hardware
25