Lenovo ThinkServer RD240 Installation And User Manual page 51

Figure 26. Installing the hard disk drive into the tray
4. Keep the handle on the hard disk drive tray assembly fully open, slide the tray
with the hard disk drive into the corresponding mounting point of the
hot-swap hard disk drive bay ( 1 ), and then slightly press the handle to lock
the tray into place ( 2 ).
Figure 27. Installing the hard disk drive tray assembly
5. Check the hard disk drive status LEDs to make sure that the hard disk drive is
operating correctly. You might have to restart the server for the drive to be
recognized. If the amber hard disk drive status LED for a drive is lit
continuously, it indicates that the drive is faulty and must be replaced; if the
green hard disk drive activity LED is flashing, this indicates that the drive is
being accessed.
Note: If the server is configured for RAID operation using a RAID controller,
you might have to reconfigure the disk arrays after you replace hard
disk drives.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation, go to "Completing the parts replacement" on
page 67.
Chapter 5. Installing, removing, or replacing hardware
37