Lenovo ThinkServer RD240 Installation And User Manual page 64

2. Remove the server cover. See "Removing the server cover" on page 21.
3. Disconnect any cables that impede access to the riser card.
4. Remove the riser card together with the installed Ethernet card. See "Removing
5. Refer to "Removing a PCI card" on page 42 and follow those instructions to
6. If you are instructed to return the Ethernet card, follow all packaging
Installing the Ethernet card
This section provides instructions on how to install the Ethernet card and how to
install the Ethernet card driver on Windows operating systems.
To install the Ethernet card, do the following:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the server cover. See "Removing the server cover" on page 21.
3. Touch the static-protective package that contains the Ethernet card to any
4. See "Installing a PCI card" on page 41 and follow those instructions to install
50
Installation and User Guide
the riser card assembly" on page 38.
remove the Ethernet card from the riser card.
instructions and use any packaging materials that are supplied to you for
shipping.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the removal procedure, go to "Completing the parts
replacement" on page 67.
Attention
Do not open your server or attempt any repair before reading and understanding the Safety
Information and the Warranty and Support Information on the ThinkServer Documentation DVD
that comes with your product, and "Guidelines" on page 19. To obtain a copy of the
publications, go to:
http://www.lenovo.com/support
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
unpainted surface on the outside of the server. Then, remove the Ethernet card
from the package.
the Ethernet card. Install the Ethernet card into the appropriate PCI card slot
(slot 2 or slot 3) on the riser card assembly (the bottom or the middle slot when
the riser card is installed on the system board).
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation, go to "Completing the parts replacement" on
page 67.