Lenovo ThinkServer RD240 Installation And User Manual page 93

Table 23. Items under the Boot menu (continued)
Item
Hard Disk Drives 1st Drive
2nd Drive
...
CD/DVD Drives 1st Drive...
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 24. Items under the Security menu
Item
Change Supervisor Password
Change User Password
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 25. Items under the Chipset menu
Item
CPU Bridge QPI Frequency
Configuration
QPI L0s and L1
Memory Frequency
Memory Mode
South Bridge Restore on AC Power
Configuration Loss
Note: The settings in [ ] are the default settings in the Setup Utility program.
Sub-item Option
Set or change the supervisor password. The
password can be any combination of up to 6
(1 to 6) alphabetic and numeric characters.
Set or change the user password. The
password can be any combination of up to 6
(1 to 6) alphabetic and numeric characters.
Sub-item Option
[Auto]
4.800GT
5.866GT
6.400GT
Disabled
[Enabled]
[Auto]
Force DDR-800
Force DDR-1066
Force DDR-1333
[Independent]
Channel Mirroring
Lockstep
Power Off
Power On
[Last State]
Description
Based on the
installed hard disk
drives.
Based on the
installed optical
drives.
Description
Description
Standard transferring
rate of the QPI bus.
Enable or disable the
QPI L0s and L1.
Set the frequency of
the memory module.
Make sure that the
mandatory memory
frequency setting is
less than the
maximum frequency
that the memory
module can support.
Set the memory
channel mode to
improve reliability or
efficiency.
If the power is
recovered after
outage, the system
will be at the state
that you set under
Restore on AC
Power Loss.
Chapter 6. Configuring the server
79