Lenovo ThinkServer RD240 Installation And User Manual page 89

Table 14. Submenus under the CPU Configuration (continued)
Item
ACPI T State
Notes:
1. The settings in [ ] are the default settings in the Setup Utility program.
2. The above options might vary depending on the type of the installed microprocessor.
Table 15. Submenus under the Mass Storage Controller Configuration
Item
SATA Configuration
Configure SATA as
Notes:
1. The settings in [ ] are the default settings in the Setup Utility program.
2. The SATA Configuration item might not apply because your server came with an
integrated SAS controller.
Table 16. Submenus under the SuperIO Configuration
Item
Serial Port1 Address
Serial Port2 Address
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 17. Submenus under the USB Configuration
Item
Legacy USB Support
USB 2.0 Controller Mode
Hotplug USB FDD Support
Note: The settings in [ ] are the default settings in the Setup Utility program.
For external USB devices, the USB Mass Storage Device Configuration submenu is as
below:
Option
Disabled
[Enabled]
Option
Disabled
[Enabled]
[IDE]
RAID
Option
Disabled
[3F8/IRQ4]
3E8/IRQ4
2E8/IRQ3
Disabled
[2F8/IRQ3]
3E8/IRQ4
2E8/IRQ3
Option
Disabled
[Enabled]
Auto
FullSpeed
[HiSpeed]
Disabled
Enabled
[Auto]
Description
Enable or disable the
microprocessor throttling in
ACPI.
Description
Enable or disable the
integrated SATA controller.
To select the hard disk drive
mode. If this option is set to
IDE, all the SATA connectors
will be configured as
stand-alone SATA connectors.
Description
Select the I/O base address
and interrupt for serial port
1.
Select the I/O base address
and interrupt for serial port
2.
Description
Enable or disable the support
on legacy USB devices.
Select the USB speed.
Enable or disable the support
on the hot-swap USB
diskette drive.
Chapter 6. Configuring the server
75