Lenovo ThinkServer RD240 Installation And User Manual page 49

Removing a hot-swap hard disk drive
Attention
Do not open your server or attempt any repair before reading and understanding the Safety
Information and the Warranty and Support Information on the ThinkServer Documentation DVD
that comes with your product, and "Guidelines" on page 19. To obtain a copy of the
publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove a hot-swap hard disk drive.
This section applies only to server models that have hot-swap hard disk drives
installed.
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each drive bay.
To remove a hot-swap hard disk drive, do the following:
Note: You do not have to turn off the server when removing a hot-swap hard disk
drive.
1. Press the blue latch to open the hard disk drive tray ( 1 ) and rotate the handle
of the hard disk drive tray assembly to the open position ( 2 ). Then, grasp the
handle and pull the hard disk drive tray assembly out of the bay ( 3 ).
Figure 24. Removing the hard disk drive tray assembly
2. Remove the four retaining screws that secure the hard disk drive in the tray.
Then, remove the hard disk drive.
3. If you are instructed to return the removed hard disk drive, follow all
packaging instructions and use any packaging materials that are supplied to
you for shipping.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the removal procedure, go to "Completing the parts
replacement" on page 67.
Chapter 5. Installing, removing, or replacing hardware
35