Table of Contents
Advertisement
Burning Guidelines into a Previously Recorded Movie
(Burn Lines)
Use the procedure below to burn guidelines into a previously recorded movie and
save the result as a new movie file. The original movie is unaffected by this operation.
After you burn guidelines into a movie, they will appear whenever the movie is played
back on the camera, including Dual Screen Play, or on a computer.
1.
In the PLAY mode, press [MENU].
2.
Press [4], use [8] and [2] to select the "p PLAY MENU" tab, and
then press [6].
3.
Use [8] and [2] to select "Burn Lines", and then press [6].
4.
Use [8] and [2] to select the type of lines you want burn and then
press [SET].
This will burn the lines into the movie and save the result as a new movie.
• Line burning takes some time to complete. Wait until the message "Busy...
Please wait..." disappears from the monitor screen.
• Pressing [MENU] while the message is displayed will stop the line burning
operation.
NOTE
• This function can be used to burn guidelines into a high-speed movie with a
playback time of at least 10 minutes or less.
• You cannot use this operation to adjust the positions of any of the lines. See pages
163, 165 and 166 for information about adjusting the positions of the guidelines.
• You can burn guidelines into a movie even if movie playback is paused. After
pausing movie playback, use [8] to display the type of lines you want to burn, and
then press [0] (Movie).
• This operation does not burn the angle values that appear during golf swing
analysis movie playback into the movie.
Using the Camera to Record and Analyze a Golf Swing
168
Advertisement
Table of Contents
