Visioneer Strobe 500 User Manual page 156

S TWAIN WIA 155
CANNING FROM AND
L D
ONG OCUMENT
Select Long document to enable support of paper sizes up to the scanner maximum. After you select this option
make sure you input the page length for your document in the custom input field, located below the Document
size selection list.
Note that some of the options in the scanner interface cannot be used when the page length will be greater than
14 inches. When you select this option, incompatible options will either be automatically disabled or the setting
will simply be discarded while scanning.
S I
TRAIGHTEN MAGE
Select this option to let the scanner automatically determine if a page is skewed, then straighten its image. This
option is only available if the scanner supports this feature.
If you are scanning using an automatic document feeder, and the page is fed through at too great of an angle, the
image may not straighten correctly. In that case, re-scan the page making sure the paper guides are adjusted to
the width of the pages in the input tray so that the pages are pulled straight through the scanner.
R I
OTATE MAGE
Select an option in this list to have the final image rotated when scanning is complete.
Flip Back Side
Select this option if you are scanning duplex pages that are calendar style orientation. This option will rotate the
back side image 180 degrees from the front side. When scanning in duplex mode without this option selected,
the back side image of calendar orientation pages will appear upside down in the final scan. This option does not
automatically determine book page orientation versus calendar page orientation. If you have this option selected
when scanning book orientation pages, the image for the back side of the page will appear upside down in the
final scan. If you are scanning a batch of documents that contain both types of orientation, we recommend that
you select Automatic in the Rotate image list.
This option is available only if the current scanner supports duplex scanning and the Duplex option is selected in
the scanning interface.
M T S
ERGE WO IDES
When scanning in duplex mode, you can enable this option to have both sides of a scanned item appear on one
page in the final image file. The options in the list allow you to select where you want the front side image to
appear in relation to the back side image in the final file.