Table of Contents
Advertisement
Install the hard drives ("Drive" on page 26).
18.
Install the hard drive blanks
19.
Install the access panel
20.
Install the server blade.
21.
After you replace the system board, you must re-enter the server blade serial number and the product ID.
During the server blade startup sequence, press the F9 key to access RBSU.
1.
Select the Advanced Options menu.
2.
Select Service Options.
3.
Select Serial Number. The following warning appears:
4.
Warning: The serial number should ONLY be modified by qualified service
personnel. This value should always match the serial number located on the
chassis.
Press the Enter key to clear the warning.
5.
Enter the serial number and press the Enter key.
6.
Select Product ID. The following warning appears:
7.
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
8.
Press the Esc key to close the menu.
9.
Press the Esc key to exit RBSU.
10.
Press the F10 key to confirm exiting RBSU. The server blade automatically reboots.
11.
Server blade release lever assembly
To remove the component:
Power down the server blade (on page 23).
1.
Remove the server blade (on page 24).
2.
Remove the access panel
3.
Remove all hard drives ("Drive" on page 26).
4.
Remove all hard drive blanks
5.
Remove all DIMM baffles
6.
Remove all DIMMs ("DIMMs" on page 29).
7.
Disconnect the capacitor pack cabling, if connected
8.
Remove the SAS controller
9.
Remove the heatsink blank, if installed
10.
Remove the front panel/hard drive cage assembly
11.
("Drive
blank" on page 26).
("Access
panel" on page 25).
("Access
panel" on page 25).
("Drive
blank" on page 26).
("DIMM
baffles" on page 28).
("SAS
controller" on page 38).
("Heatsink
("FBWC capacitor pack
blank" on page 31).
("Front panel/drive cage
Removal and replacement procedures 62
cabling" on page 71).
assembly" on page 49).
Advertisement
Table of Contents
