Install the DIMM.
2.
Install all DIMM baffles
3.
Install the access panel
4.
To configure the memory mode, use RBSU
5.
Heatsink blank
To remove the component:
Power down the server blade (on page 23).
1.
Remove the server blade (on page 24).
2.
Remove the access panel
3.
Remove the SAS controller
4.
Remove the heatsink blank.
5.
("DIMM
baffles" on page 28).
("Access
panel" on page 25).
("HP ROM-Based Setup
("Access
panel" on page 25).
("SAS
controller" on page 38).
Utility" on page 67).
Removal and replacement procedures 31