Doprotection; Filter:alpha - Agilent Technologies N5171B Command Reference Manual

Arb Commands
Dual ARB Subsystem–N5172B/82B ([:SOURce]:RADio:ARB)
IORQ This choice clips I and Q separately. When this choice is enabled, percentage
values for both I and Q must be specified.
*RST
IJQ
Range <value>: 10–100 (0.1% resolution)
Clipping Type |I+jQ| |I|,|Q|
Key Entry
Remarks A value of 100 percent equates to no clipping.
For information on the file name syntax, refer to
page

:DOPRotection

Supported N5172B/82B
[:SOURce]:RADio:ARB:DOPRotection ON|OFF|1|0
[:SOURce]:RADio:ARB:DOPRotection?
This commands turns the DAC over–range protection feature off or on.
The over–range protection feature works only with the Baseband Frequency Offset feature and the
Option 432 Phase Noise Impairment.
On Minimizes the occurrence of a DAC over–range condition. In doing so, it can also
decrease the dynamic range of the waveform by scaling the data more than what
is actually needed. For the Baseband Frequency Offset feature, this protection is
active only when the offset parameter is a value other than 0 Hz.
Off The automatic protection feature is not enabled. To correct a DAC over–range
condition, reduce the waveform runtime scaling value (see
page
*RST ON
Key Entry DAC Over–range Protection Off On

:FILTer:ALPHa

Supported N5172B/82B
[:SOURce]:RADio[1]:ARB:FILTer:ALPHa <value>
[:SOURce]:RADio[1]:ARB:FILTer:ALPHa?
This command changes the Nyquist or Root Nyquist Real- Time Modulation filter alpha value.
The filter alpha value can be set to the minimum level (0), the maximum level (1), or in between by
using fractional numeric values (0.001 to 0.999).
*RST +3.50000000E001
Range 0.000 to 1.000
Key Entry Filter Alpha
Remarks To change the current filter type, refer to :FILTer:TYPE.
274
<value>: +100
13.
298).
"File Name Variables" on
Agilent X-Series Signal Generators SCPI Command Reference
":RSCaling" on