KTM 450 EXC EU Owner's Manual page 95

SERVICE WORK ON THE ENGINE
–
Remove screw plug
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
C00066-10
–
Mount and tighten screw plug
Guideline
Screw plug, gear oil screen
C00067-11
–
Push the engine oil screen with the O-rings onto a pin wrench.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
C00068-10
–
Mount and tighten screw plug
Guideline
Screw plug, engine oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
C00069-10
–
Remove screws
C00070-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
C00071-10
with engine oil screen

with the gear oil screen and the O-rings.

with the O-ring.

with the magnet and a new seal ring.

. Remove the oil filter cover with the O-ring.

out of the oil filter housing.

and the O-rings.

M20x1.5 15 Nm
(11.1 lbf ft)
M20x1.5 15 Nm
(11.1 lbf ft)
M12x1.5 20 Nm
(14.8 lbf ft)
93