Loosening The Fork Protector; Positioning The Fork Protection; Removing The Fork Legs - KTM 450 EXC EU Owner's Manual

SERVICE WORK ON THE CHASSIS

Loosening the fork protector

10.5

Positioning the fork protection

10.6

Removing the fork legs

10.7
–
Press the dust boots back into their normal position.
–
Remove excess oil.
–
Position the fork protection. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Remove screws
–
Remove the screws on the right fork leg. Push the fork protector downwards.
101321-10
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the wiring harness.
–
Position the brake line. Put the clamp on, mount and tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
101321-11
–
Remove the headlight mask with the headlight. (
–
Remove the front wheel.
–
Remove screws
–
Remove cable binder
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
101322-10
(EXC EU, EXC AUS, All XC‑W models)
–
Unscrew screws
–
Loosen screws
101323-10
(EXC SIX DAYS)
–
Release screws
–
Release screws
101324-10
p. 43)
and remove the clamp.

on the left fork leg. Push the fork protector downwards.

M6
M6
( p. 74)
x
and take off the clamp.

.

and take off the brake caliper.

. Take out the left fork leg.

. Take out the right fork leg.

. Take out the left fork leg.

. Take out the right fork leg.

p. 42)

10 Nm (7.4 lbf ft)
.

10 Nm (7.4 lbf ft)
p. 83)
43
.