Miller Electric Trailblazer Pro 350 Owner's Manual page 40

Engine driven welding generator
Hide thumbs Also See for Trailblazer Pro 350:
Table of Contents

Advertisement

C. Engine
Trouble
Engine will not crank.
Engine cranks, but does not start.
Engine starts but stops when Engine
Control switch is released.
Engine does not stop.
Engine stopped during normal
operation.
Battery discharges between uses.
OM-4401 Page 36
Reset circuit breaker CB8 (see Section 7-9).
Check battery voltage.
Check battery connections and tighten if necessary.
Have Factory Authorized Service Agent check Engine Control switch S1.
Check fuel level (see Section 4-2).
Open fuel valve (see Section 4-2).
Check oil level (see Section 4-2). Engine will not start if oil pressure is low.
Reset circuit breaker CB10 (see Section 7-9).
Check coolant level and fan belt (see Section 4-2 and engine manual). Engine will not start if coolant
temperature is high.
Use Glow Plug if unit does not start in cold weather. If unit still does not start, reset circuit breaker
CB7 (see Section 7-9).
Service primary and secondary fuel filters (see Section 7-5).
Check battery and replace if necessary.
Check engine charging system according to engine manual.
Bleed air from fuel system according to engine manual.
Have Factory Authorized Service Agent check low oil pressure switch S4, engine coolant tempera-
ture switch S5, and control relay CR1.
See engine manual.
Check oil level (see Section 4-2). Engine will not start if oil pressure is too low.
Reset circuit breaker CB10 (see Section 7-9).
Check coolant level and fan belt (see Section 4-2 and engine manual). Engine will not start if engine
temperature is too high.
Check and refill crankcase with proper viscosity oil for operating temperature, if necessary (see en-
gine manual).
Have Factory Authorized Service Agent check low oil pressure switch S4 and engine coolant temper-
ature switch S5.
Stop engine by pushing down engine stop lever (see Section 4-2) or closing fuel valve (see Section
4-2). After stopping engine, adjust fuel solenoid linkage (see engine manual).
Check fuel level (see Section 4-2).
Open fuel valve (see Section 4-2).
Check oil level (see Section 4-2). Engine stops if oil pressure is too low.
Check coolant level and fan belt (see Section 4-2 and engine manual). Engine stops if engine temper-
ature is too high.
Bleed air from fuel system according to engine manual.
Have Factory Authorized Service Agent check low oil pressure switch S4 and engine coolant temper-
ature switch S5.
Clean top of battery with baking soda and water solution; rinse with clear water.
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check voltage regulator according to engine manual.
Remedy

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents