Process/Contactor Switch; Operating Unit At Idle Speed - Miller Electric Trailblazer Pro 350 Owner's Manual

5-3. Process/Contactor Switch

Switch Setting
Remote – TIG
Remote – Stick
Remote – MIG
Electrode Hot – MIG
Electrode Hot – Stick
Electrode Hot – Scratch
Start TIG

5-4. Operating Unit At Idle Speed

OM-4401 Page 22
Process/Contactor Switch Settings
Process
GTAW With HF Unit, Pulsing Device,
Or Remote Control
Stick (SMAW) With Remote On/Off
MIG (GMAW)
MIG (GMAW)
Stick (SMAW),
Air Carbon Arc (CAC-A) Cutting And Gouging
Scratch Start TIG (GTAW)
1
1
Y Weld output terminals are en-
Use switch to select weld process
and weld output on/off control (see
table below and Section 5-5).
Place switch in Remote positions to
turn weld output on and off with a de-
vice connected to the remote 14 re-
ceptacle.
Place switch in Electrode Hot posi-
tions for weld output to be on whenev-
er the engine is running.
Use Stick position for air carbon arc
(CAC-A) cutting and gouging.
Output On/Off Control
At Remote 14 Receptacle
At Remote 14 Receptacle
At Remote 14 Receptacle
1 Engine Speed Switch
Use Idle speed when:
D
Starting
D
1
Stick welding at up to 180 A.
To weld above 180 A, place Engine
Speed switch in Run or Run/Idle
position.
When Stick welding at idle speed, the
front panel Voltage/Amperage control
setting is accurate up to 180 A. Above
180 A, weld output is slightly less than
Voltage/Amperage control setting.
.
Place switch in Run or Run/Idle posi-
tion when using generator power.
.
Place switch in Run position to oper-
ate most GMAW equipment.
Process/Contactor Switch
ergized when Process/Con-
tactor switch is in any Elec-
trode Hot position and the en-
gine is running.
203 031-A-A / 802 580-A
Electrode Hot
Electrode Hot
Electrode Hot
203 031-A / 802 580-A