Installing Boom And Reel Support; Installing Wire Guide Extension - Miller Electric Swingarc Owner's Manual

3-4. Installing Boom And Reel Support

4
5
6
1
Tools Needed:
3/8, 3/4 in

3-5. Installing Wire Guide Extension

Tools Needed:
3/8 in
3
7
2
1
4
3
2
1 Swivel Plates
2 Yoke
Remove hardware from swivel
plates and yoke.
3 Boom
Set boom into swivel as shown.
4 Yoke Pin
Install pin through yoke. Install cot-
ter pin and spread ends.
5 Bolt
Install bolt, tighten hardware, and
back bolt off one half turn.
6 Locking Knob
Install locking knob but do not
tighten.
7 Reel Support
Install reel support.
ST-142 596-C
1 Wire Guide Fitting
2 Bolt
3 Monocoil Liner
4 Wire Guide Extension
Tighten bolt to secure liner in wire
guide fitting. Do not overtighten bolt
and crush liner.
ST-152 323
OM-1583 Page 11