NordicTrack Audio Rider R400 Bike User Manual page 7

5. The Console (4) requires four "D" batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. Remove the battery cov-
ers from the back of the Console. Next, insert four
batteries into the battery compartments; make sure
that the batteries are oriented as shown by the
diagrams inside the battery compartments.
Then, reattach the battery covers.
Note: The Console (4) can be operated with an
optional power supply instead of batteries. To pur-
chase a power supply, call the toll-free tele-
phone number on the front cover of this manual.
Plug one end of the power supply into the jack at
the front of the exercise cycle. Plug the other end of
the power supply into an appropriate outlet that is
properly installed in accordance with all local codes
and ordinances.
6. Attach the Handlebar (39) to the Upright (2) with
four M6 x 30mm Button Screws (37).
7. While another person holds the Console (4) near
the Handlebar (39), connect the wire harness on the
Console to the Main Wire Harness (43). Next, con-
nect the pulse wire on the Console to the Pulse
Wire (51) in the Handlebar (39). Note: The remain-
ing wire on the Console is used during the manufac-
turing process; disregard this wire.
Insert the excess wiring downward into the Upright
(2). Attach the Console (4) to the Handlebar (39)
and the Upright with four M4 x 16mm Round Head
Screws (80). Be careful to avoid pinching the
Wires (43, 51).
5
Batteries
4
6
2
7
80
80
2
7
Battery
Covers
Batteries
37
37
39
Wire
Harness
43
4
Pulse
51
Wire
39
Avoid pinching
the Wires (43, 51)
during this step