Maintenance And Troubleshooting; Battery Replacement; To Level/Move Exercise Cycle - NordicTrack Audio Rider R400 Bike User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. Important: To avoid dam-
age to the console, keep liquids away from the
console and keep the console out of direct sun-
light.

BATTERY REPLACEMENT

If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 5 on page
7 for replacement instructions.
HOW TO LEVEL THE EXERCISE CYCLE
After the exercise
cycle has been
moved to the
location where it
will be used,
make sure that
both ends of the
front stabilizer are
touching the floor.
If the exercise
cycle rocks slight-
ly during use, turn one or both of the leveling feet
under the front stabilizers until the rocking motion is
eliminated.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper-
ly, see step 5 on page 13.
HOW TO MOVE THE EXERCISE CYCLE
To move the exercise cycle, hold the handle on the
rear stabilizer and carefully lift it until the exercise
cycle can be moved on the front wheels. Carefully
move the exercise cycle to the desired location and
then lower it.
Wheel
Leveling Foot
17
Handle