Kenwood DNX7380BT Instruction Manual page 86

operation
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
and [User] using [2] and [3].
Controlling SystemQ-Ex
Selects items to be adjusted for tone curve
setup. If you turn off this setting, only Level
can be set up for tone curves.
1
Touch [ON] or [OFF] of [SystemQ-Ex].
Controlling equalizer manually
1
Touch [Tone] in the Equalizer screen.
2
Set each item as follows.
FREQ
Adjusts the center frequency for each range.
Setting values are as follows.
Bass: 4 0Hz/50Hz/60Hz/70Hz/80Hz/100Hz/120
Hz/150Hz (Default is "100Hz. " )
Middle: 5 00Hz/1kHz/1.5kHz/2kHz (Default is
"1kHz. " )
Treble: 1 0kHz/12.5kHz/15kHz/17.5kHz (Default
is "12.5kHz. " )
LEVEL
Adjusts the level of each range.
Each setting value is within -8dB and 8dB and
default is "0dB. "
Q Factor
Adjust Q value for bass and middle.
Setting values are as follows.
Bass: 1/1.25/1.5/2 (Default is "1. " )
Middle: 1/2 (Default is "1. " )
Bass DC EXT
Turns Bass DC EXT on or off. Default is "OFF. "
If you select "ON", the bass center frequency is
extended to the low register by approximately
20%.
[Flat]
Tone level becomes 0 (flat).
Subwoofer Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to "None".
See Speaker setup (P.80).
Return to the Top page
Audio Setting Up
85