Ext Sw Setup - Kenwood DNX7380BT Instruction Manual

Return to the Top page
Setting Up
2
Touch [ON] of [SI].
NOTE
• If "SI" is turned on, the SI indicator on the sub
panel flashes when the vehicle ignition is off and
the panel is detached. Default is "ON. "
3
Touch [SET] of [Security Code Set].
NOTE
• If you have already completed the code
registration, [CLR] is displayed.
4
Enter a security code with four-digit
number and touch [Enter].
5
Enter the same code again and touch
[Enter].
Security code is registered.
NOTE
• If you enter a different security code, the screen
returns to step 4 (for the first code entry).
• If you have pressed <Reset> button or if you
have disconnected the Receiver from battery,
enter the correct security code as that you have
entered in step 4 and touch [Enter]. You can use
your Receiver.
72 72

EXT SW setup

Set up the external switch power mode.
1
Touch [EXT SW] in the System Menu
screen.
EXT SW screen appears.
2
Set each item as follows.
SW1 Name/SW2 Name
Sets the name of the external device.
Output Pattern
Sets the power signal output mode among
"Pulse"/"Level". Default for EXT SW1 is "Pulse"
and for EXT SW2 is "Level".
You can set to turn output on/off each time
the button on the EXT SW screen is touched.
See External Device Control (P.79)
Pulse Set
Sets the pulse signal output time.
Outputs 500ms when "1" is set.
Increases by 200ms with each step. Up to 100
steps can be set.
NOTE
• You can enter characters only after you have
applied the parking brake.
• "Pulse": Generates a single power signal pulse.
• "Level": Continues output of high power signal.