4 Replacement Procedures
4.21 GFX board/GFX fin
4.21 GFX board/GFX fin
Removing the GFX board/GFX fin
To remove the GFX board/GFX fin, follow the steps below and refer to Figure 4-38 and 4-39.
1. Remove the following screws and disconnect the GFX board (with the GFX fin)
from the connector CN5900 on the system board.
•
×2
M2.0×4B
BIND screw
M2.0x4B BIND
CN5900
GFX board
GFX fin
Figure 4-38 Removing the GFX board/GFX fin (1)
4-62
[CONFIDENTIAL]
TECRA M10 Maintenance Manual (960-685)